UV LIGHT SOURCES

POWERFUL TECHNOLOGY FOR ALL REHABILITATION JOBS

UV LIGHT CHAIN DN 150 – DN 500

  • 8 x 400 W or 8 x 600 W
  • The diameter to be rehabilitated is achieved through corresponding wheel extensions
  • It can also be extended for egg-shaped profiles of 300/450 to 400/600
  • Sixteen “crosses” are needed for the conversion to egg-shaped profiles, which are screwed around the round housing of the individual elements of the light source

UV DOUBLE CORE 8 X 1000 WATT

  • 2 x 4 x 1,000 W
  • Nominal diameter adaptation of the core using electric drive and can be observed using a camera in the packer
  • In retracted state, the core can thus be installed quickly and without problems
  • Additional ease-of-use: the setup procedure is automatically switched off as soon as the set diameter is reached
  • Two cores can be connected in one pull to increase the pulling speed

UV DOUBLE CORE FOR EGG-SHAPED PROFILES

  • 2 x 4 x 1,000 W
  • Wheel extension for egg-shaped profiles
  • In retracted state, the core can thus be installed quickly and without problems
  • Additional ease-of-use: the setup procedure is automatically switched off as soon as the set diameter is reached

UV JUMBO CORE

  • 3 x 6 x 1,000 W
  • A UV core carries 6 lamps, each with a power output of 1,000 watts
  • To increase the pulling speed, up to three cores can be lined up, one after the other, allowing an increase of the lamp output to up to 18,000 watts